Mon - Fri 08:00 - 17:00 & Sat 08:00 - 14:00
info@kantarzoglou.gr
Greeceuk

Work protection - Safety Equipment - Safety Gloves

Gloves giving protection from mechanical risks

Protection against mechanical hazards is expressed by a pictogram followed by four numbers (performance levels), each representing test performance against a specific hazard.

1 Resistance to abrasion

Based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the glove. See table below.

2 Blade cut resistance

Based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 4.

3 Tear resistance

Based on the amount of force required to tear the sample.
The protection factor is then indicated on a scale from 1 to 4.

4 Puncture resistance

Based on the amount of force required to pierce the sample with a standard sized point. The protection factor is then indicated on a scale from 1 to 4.

collapse
Νο more products